1. Bugi không cháy khi đánh lửa.
Khi đánh lửa, giữa bugi và thân bộ phận đánh lửa phải có tia lửa phóng điện rõ ràng, có thể nhìn thấy rõ tia lửa điện và có thể nghe thấy tiếng phóng tia lửa điện rõ ràng.
If the spark plug does not ignite, first check whether the ignition indicator light of the main control board is on for 1-2 seconds when the "test fire" button is operated to confirm whether the ignition control of the main control board is correct.
Cho dù có sự tích tụ carbon trên bugi cũng sẽ làm cho bugi không đánh lửa, và nó cần được làm sạch.
Tiếp theo, hãy kiểm tra gói điện áp cao - được kết nối với bugi, cũng như kết nối và phích cắm kết nối của chúng.
Đặt DC3V (hai pin thông thường) vào đầu vào của gói điện áp - cao và phóng tia lửa điện phải được tạo ra giữa hai đường đầu ra của gói điện áp - cao (khoảng cách giữa hai đường là 2 - 10mm), nếu không gói cao áp sẽ bị hỏng.
2. Không có khí thoát ra khi đánh lửa.
While operating the "Test Fire" button, you can use an open flame to ignite the ignition at the igniter of the CNC cutting machine, so as to confirm whether there is gas ejected during ignition.
If no gas is ejected, check the main control board and the solenoid valve indicator light according to the gas circuit fault inspection and troubleshooting method. If the indicator lights of the main control board and the solenoid valve are normal and there is no valve blockage, it is possible that the small hole of the gas nozzle on the igniter is blocked. The way to confirm the diagnosis is to loosen the nut under the adjustment knob on the igniter, put the knob in the water, and see if there is gas spewing out when it is ignited. If there is gas here and there is no gas where the igniter spits out, the gas nozzle must be blocked. The hole of the gas nozzle is very small, Ф0.4mm. The treatment method is to use a hacksaw blade to grind out a slender tip, and then use it to straighten the hole.